![]() Click Refresh to run the discovery process again.You must add the access point to the managed list, change its IP address, and run the discovery process again to discover the next access point with that IP address. Note: If more than one access point has the same IP address, only one is discovered at a time. Ensure the DHCP server is available on the wireless controller or network. ![]() If the discovery results are not what you expect, check the following: If the wireless controller already manages a particular access point, it will not display in the discovery list. Discovery works best if each access point is configured with a unique IP address and is running current firmware. The effectiveness of the discovery process depends on how the access points are set up on your LAN. ![]() Review the discovery results to ensure all access points are listed.Use the Search field to find an individual access point.The green bar displays the progress of the discovery process.Įach discovered access point is displayed in a table by MODEL, IP, MAC address, and Site. The wireless controller searches for NETGEAR products on the LAN based on MAC address and then identifies which access point models are supported. Click ADD again if a third set is needed.ĭiscovery Wizard Step 3 of 3: Select Access Points to manage screen displays. The screen adjusts to display a second set of Start IP and End IP fields. Click ADD if more IP address ranges are required. ![]() The IP addresses specify the range in which the wireless controller should discover access points.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |